HD Half Arrow – 800mm Wear Edge

• Compatible with all Sandvik and non-Sandvik loader buckets.
• No structural modifications required to install system.
• Faster GET change-outs than replacing the entire lip.

• Extend bucket service life.
• Maintain bucket capacity for longer.
• Reduce the frequency of lip rebuilds.
• Reduce the total cost of ownership of loader and bucket.

Suitable for medium to large-sized loaders operating in normal to aggressive mining conditions.

Lip thickness range = 40mm – 50mm.

Item number: 69037843 Category: Tag:

The Half Arrow Series is a range of weld-on lip protection systems designed to extend the life of loader buckets by preserving the structure of the primary lip. The range’s advanced design allows for good penetration of muck piles and optimization of material flows during dumping. GET in the Half Arow range are constructed from a Sandvik wear-resistant alloy that delivers a high performance-to-weight ratio.

• Constructed from custom high-performance, wear-resistant Sandvik SS2000 steel alloy.
• Dedicated corner edges protect high-wearing zones.
• Self-sharpening profile to maintain mucking performance.
• Optimized for maximum GET wear and reduced waste material at end of life.
• Built-in weld prep areas for easy installation.


Sandvik LH307, Sandvik LH410, Sandvik LH514, Sandvik LH517, Sandvik LH621, Caterpillar R1300, Caterpillar R1600, Caterpillar R1700, Caterpillar R2900, Caterpillar R3000, Epiroc ST1030, Epiroc ST14, Epiroc ST18, Epiroc ST7


Heavy duty